Ud Composite(Ud 합성)란 무엇입니까?
Ud Composite Ud 합성 - In this paper, additional fibre architectural features affecting the compressive strength of UD composites, and to be considered in strength analyses of UD NCF reinforced carbon fibre composites, are discussed. [1] It is observed that MRR is seen to be less, and TWR and ROC are found to be high for Al7075-TiC composites when compared to the Al7075-red mud composites. [2] The tensile property of the Q3D composite has been found to be competitive with UD composite. [3] Damage mechanisms are found to be similar in the stem and within flax-based UD materials, namely by buckling of fibre bundles, a typical failure mechanism of UD composites. [4] Letting the predicted transverse tensile strength of a UD composite with an initial perfect and later cracked interface be equal to the measured corresponding value, a critical von Mises stress of matrix at which the interfacial cracks appear is obtained. [5] This criterion is energy based and is able to predict the toughness of UD composites. [6] The UD composite is assumed to fail when either the fiber or the matrix failure criterion is satisfied. [7] Finally, to allow for an evaluation of the effects of mean stress, constant fatigue life diagrams for 0°, 10°, and 90° UD composites are established based on four-segment anisomorphic model. [8]이 논문에서는 UD 복합 재료의 압축 강도에 영향을 미치고 UD NCF 강화 탄소 섬유 복합 재료의 강도 분석에서 고려되어야 하는 추가적인 섬유 구조적 특징에 대해 논의합니다. [1] Al7075-적니 복합재와 비교할 때 Al7075-TiC 복합재의 경우 MRR이 더 적은 것으로 나타났으며 TWR 및 ROC가 높은 것으로 관찰되었습니다. [2] Q3D 합성물의 인장 특성은 UD 합성물과 경쟁력이 있는 것으로 밝혀졌습니다. [3] 손상 메커니즘은 줄기와 아마 기반 UD 재료 내에서 유사한 것으로 밝혀졌습니다. 즉, UD 복합재의 전형적인 파손 메커니즘인 섬유 다발의 좌굴에 의한 것입니다. [4] 초기 완전 및 나중에 균열된 계면을 갖는 UD 복합재의 예측된 횡방향 인장 강도를 측정된 해당 값과 동일하게 하면 계면 균열이 나타나는 매트릭스의 임계 von Mises 응력이 얻어집니다. [5] 이 기준은 에너지 기반이며 UD 합성물의 인성을 예측할 수 있습니다. [6] UD 합성물은 Fiber 또는 Matrix 파손 기준이 충족될 때 파손되는 것으로 가정합니다. [7] 마지막으로, 평균 응력의 영향을 평가할 수 있도록 0°, 10° 및 90° UD 복합 재료에 대한 일정한 피로 수명 다이어그램이 4-세그먼트 이형 모델을 기반으로 설정되었습니다. [8]