Surface Jet(표면 제트)란 무엇입니까?
Surface Jet 표면 제트 - In low winds (≲2 m s−1), diurnal warm layers form but shear in the near-surface jet is too weak to generate shear instability and mixing. [1] Contrariwise, an electrically conductive lateral wall is found to enhance the free-surface jet and to modify the Hartmann layer structure. [2] The VOF (volume of fluid) method was applied to track free water surface, and the Realizable turbulent model was used to close the two-phase flow time-averaged equation to numerically simulate the hydraulic characteristics of surface jet on horizontal base plate with shallow depth. [3] A free simulation with the regional polar version of the Weather Research and Forecasting model (Polar WRF) (at a 35 km resolution) over the entire continent shows too-strong and too-shallow near-surface jets in katabatic regions especially in winter. [4] In this study, the results of NREL’s continued work on experimental characterization of the thermal performance of free-surface jets of automatic transmission fluid impinged on a heated target surface are presented. [5] Further development may involve the identification of dimensionless parameters and specific correlations for CHF under free-surface jets. [6]낮은 바람(≲2 m s-1)에서는 주간 따뜻한 층이 형성되지만 표면 근처 제트의 전단은 너무 약하여 전단 불안정성과 혼합을 생성합니다. [1] 반대로, 전기 전도성 측벽은 자유 표면 제트를 향상시키고 Hartmann 층 구조를 수정하는 것으로 밝혀졌습니다. [2] VOF(Volume of Fluid) 방법을 적용하여 자유수면을 추적하고, Realizable 난류모델을 사용하여 2상 유동 시간 평균 방정식을 닫고 깊이가 얕은 수평 바닥판에서 표면 제트의 수리적 특성을 수치적으로 시뮬레이션했습니다. . [3] 무료 시뮬레이션 날씨 연구 및 예측 모델의 지역 극지방 버전 (Polar WRF) (해상도 35 km) 대륙 전체에 걸쳐 특히 카타바틱 지역에서 너무 강하고 너무 얕은 표면 근처 제트 겨울에. [4] 이 연구에서는 가열된 목표 표면에 충돌하는 자동 변속기 유체의 자유 표면 제트의 열 성능에 대한 실험적 특성화에 대한 NREL의 지속적인 작업 결과가 제시됩니다. [5] 추가 개발에는 자유 표면 제트에서 CHF에 대한 무차원 매개변수 및 특정 상관 관계의 식별이 포함될 수 있습니다. [6]
Free Surface Jet
The flow of a planar liquid free surface jet impinging on a porous layer is theoretically examined, with particular emphasis on the influence of porosity ϕ, stress jump coefficient χ, and depth of the porous layer on the super- and sub-critical regions. [1] An experimental investigation was conducted in order to study heat transfer between a vertical free surface jet and a horizontal stainless steel heated plate. [2] Different turbulent models ( k − ϵ , k − ω , v 2 f ) are compared to predict velocity field of the free surface jet, and the most suitable turbulence model is identified for prediction of flow physics of free surface jet impingement. [3]다공성 층에 충돌하는 평면 액체 자유 표면 제트의 흐름은 다공성 ϕ, 응력 점프 계수 χ 및 초임계 및 아임계 영역에 대한 다공성 층 깊이의 영향에 특히 중점을 두고 이론적으로 조사됩니다. [1] 수직 자유 표면 제트와 수평 스테인리스강 가열판 사이의 열 전달을 연구하기 위해 실험적 조사가 수행되었습니다. [2] 자유 표면 제트의 속도장 예측을 위해 서로 다른 난류 모델( k − ϵ , k − ω , v 2 f )을 비교하고 자유 표면 제트 충돌의 유동 물리학 예측에 가장 적합한 난류 모델을 식별합니다. [3]
surface jet impingement
In this work, the spreading liquid pool was characterized as a free-surface jet impingement on the plate surface. [1] Different turbulent models ( k − ϵ , k − ω , v 2 f ) are compared to predict velocity field of the free surface jet, and the most suitable turbulence model is identified for prediction of flow physics of free surface jet impingement. [2] Although some flat surface jet impingement cases are described in the literature, the validated data is still limited. [3]이 작업에서 확산 액체 풀은 플레이트 표면에 대한 자유 표면 제트 충돌로 특성화되었습니다. [1] 자유 표면 제트의 속도장 예측을 위해 서로 다른 난류 모델( k − ϵ , k − ω , v 2 f )을 비교하고 자유 표면 제트 충돌의 유동 물리학 예측에 가장 적합한 난류 모델을 식별합니다. [2] 일부 평면 제트 충돌 사례가 문헌에 설명되어 있지만 검증된 데이터는 여전히 제한적입니다. [3]