Explosive Source(폭발원)란 무엇입니까?
Explosive Source 폭발원 - To reveal the characteristics and laws of the seismic wavefield amplitude-frequency excited by explosive source, the method for computing the seismic wave spectrum excited by explosive was studied in this paper. [1] In a special near field experiment using the explosive source, the back-azimuths and phase velocity are estimated by the recorded acceleration and rotation rate. [2] 75 kt of ammonium nitrate as explosive source. [3] Also, as electric spark and electrodynamic sources, used mainly in works of the upper part of the section, non-explosive sources, which have become widespread, include pneumatic sources. [4] The experimental distorted RIS data induced by an explosive source are imported into the well-trained CGAN, and the precise interference striations are obtained. [5] Again, the algorithm processing results are consistent with the single-shot record characteristics of an explosive source. [6] Variability in the propagation path is considered using archived atmospheric specifications and implies that despite uncertainties related to the dynamic and sparsely sampled nature of the atmosphere, thermospheric signatures might be useful in estimating the yield for explosive sources. [7] The results verify the similarity between the electric spark source and the explosive source. [8] The amplitude-frequency characteristics of seismic wave field excited by an explosive source can directly affect the accuracy of seismic prospecting. [9] For an explosive source, the kernels of the diving/direct wave and PP-reflections and the kernel of the PS-reflections are used to compute the P- and S-wave gradients of the background models, respectively. [10] This paper describes the performance of the FAST algorithms developed to approximate incident blast metrics from high-explosive sources using only data from body-mounted blast sensors. [11] The results showed that the closer the point to the explosive source, the sooner the impression and damage was caused by the blast. [12] Finally, we develop design charts to be used as a straightforward decision making tool for determining the critical stand-off distance between the explosive source and the target in order to prevent overturning. [13] Here, we studied the dynamic response of PE pipes situated near an explosive source. [14] The use of a non-explosive source of excitation of seismic vibrations made it possible to carry out research in urban areas. [15] Ultra-high energy (UHE; E > 10 PeV) neutrinos probe the most distant, most explosive sources in the Universe, often obscured to optical telescopes. [16] Bottom reflection of broadband waveforms from explosive sources leads to pulse distortion, including the presence of a precursor to the main pulse, a topic that goes back to the 1950s [Arons and Yennie, JASA 22, 231–237 (1950)). [17] Results: The majority of participants had third-degree burns from explosive sources either at their place of residence or the work-place. [18] Experimental data results verified the effectiveness of the PF method with the vertical wave impedance for the localization of the explosive source. [19] Events are associated confidently with known sources, with accurately determined origin times, usually by applying waveform correlation or similar techniques to the characteristic seismic signals generated by each explosive source. [20] In the mining industry, the ratio of S-wave energy to P-wave energy is regarded as an important indicator of the type of focal mechanism, with the ratio being lower for explosive sources and higher for fault slip (Cai et al 1998, Mendecki, 2013). [21]본 논문에서는 폭발원에 의해 여기된 지진파장 진폭-주파수의 특성과 법칙을 밝히기 위해 폭발물에 의해 여기된 지진파 스펙트럼을 계산하는 방법을 연구하였다. [1] 폭발원을 이용한 특수 근거리 실험에서 후방 방위각과 위상 속도는 기록된 가속도와 회전 속도로 추정됩니다. [2] 폭발원으로 질산암모늄 75kt. [3] 또한, 주로 상부 구간의 공사에 사용되는 전기스파크 및 전기역학원으로서 보편화되고 있는 비폭발성원에는 공압원 등이 있다. [4] 폭발원에 의해 유도된 실험적인 왜곡된 RIS 데이터를 잘 훈련된 CGAN으로 가져와 정확한 간섭 줄무늬를 얻습니다. [5] 다시 말하지만, 알고리즘 처리 결과는 폭발원의 단일 샷 기록 특성과 일치합니다. [6] 전파 경로의 변동성은 보관된 대기 사양을 사용하여 고려되며 대기의 동적 및 드물게 샘플링된 특성과 관련된 불확실성에도 불구하고 열권 서명이 폭발 소스의 수율을 추정하는 데 유용할 수 있음을 의미합니다. [7] 결과는 전기 스파크 소스와 폭발 소스 사이의 유사성을 확인합니다. [8] 폭발원에 의해 여기된 지진파장의 진폭-주파수 특성은 지진 탐사의 정확도에 직접적인 영향을 미칠 수 있습니다. [9] 폭발원의 경우 잠수/직접파의 커널과 PP 반사의 커널과 PS 반사의 커널을 사용하여 배경 모델의 P 및 S파 기울기를 각각 계산합니다. [10] 이 백서에서는 신체에 장착된 폭발 센서의 데이터만 사용하여 고 폭발 소스의 사고 폭발 메트릭을 근사화하기 위해 개발된 FAST 알고리즘의 성능에 대해 설명합니다. [11] 그 결과 폭발원에 가까울수록 폭발로 인한 인상과 손상이 더 빨리 발생하는 것으로 나타났습니다. [12] 마지막으로, 우리는 전복을 방지하기 위해 폭발원과 표적 사이의 임계 격리 거리를 결정하기 위한 간단한 의사 결정 도구로 사용할 설계 차트를 개발합니다. [13] 여기에서 폭발원 근처에 위치한 PE 파이프의 동적 응답을 연구했습니다. [14] 지진 진동의 비폭발성 여기 소스를 사용하여 도시 지역에서 연구를 수행할 수 있었습니다. [15] 초고에너지(UHE; E > 10 PeV) 중성미자는 우주에서 가장 멀리 떨어져 있고 가장 폭발적인 소스를 탐사하며 종종 광학 망원경으로 가려지지 않습니다. [16] 폭발성 소스로부터의 광대역 파형의 바닥 반사는 1950년대로 거슬러 올라가는 주제인 메인 펄스의 전구체 존재를 포함하여 펄스 왜곡으로 이어집니다[Arons and Yennie, JASA 22, 231–237(1950)). [17] 결과: 대부분의 참가자는 거주지나 직장에서 폭발성 물질로 인해 3도 화상을 입었습니다. [18] 실험 데이터 결과 폭발원의 위치 파악을 위한 수직파 임피던스를 이용한 PF법의 유효성을 검증하였다. [19] 이벤트는 일반적으로 각 폭발 소스에서 생성된 특성 지진 신호에 파형 상관 관계 또는 유사한 기술을 적용하여 정확하게 결정된 시작 시간과 함께 알려진 소스와 확실하게 연관됩니다. [20] 광산업에서 S파 에너지 대 P파 에너지의 비율은 초점 메커니즘 유형의 중요한 지표로 간주되며, 폭발원의 경우 비율이 낮고 단층 슬립의 경우 비율이 높습니다(Cai et al 1998, Mendecki , 2013). [21]