Alumina Nanofibers(알루미나 나노섬유)란 무엇입니까?
Alumina Nanofibers 알루미나 나노섬유 - The ionic selectivity is investigated experimentally by measuring the membrane potential at zero current for C–Nafen membranes prepared from alumina nanofibers with conductive carbon coating. [1] This work shows the effectiveness of the aforementioned concept achieved through the incorporation in a reference HPFRCC of three types of nano-constituents: alumina nanofibers (0. [2] In this work, we propose a novel composite material based on alumina nanofibers and detonation nanodiamonds for detection of phenol in aqueous medium. [3] In this study, silica (SiO2) nanoparticles were deposited on the surfaces of micro-synthetic polypropylene (PP) fibers through the sol-gel process and combined with Alumina Nanofibers (ANF's) to enhance the cement composite mechanical properties. [4] A composite of alumina nanofibers (ANF) and modified detonation nanodiamonds (MDND) was produced by mixing aqueous suspensions of the components in a weight ratio of 5 : 1 with subsequent incubation of the mixture for 15 min at 32°C. [5] Anodizing aluminum in pyrophosphoric acid caused the successive formation of a barrier oxide film, a porous oxide film, pyramidal bundle structures with alumina nanofibers, and completely bent nanofibers. [6] Aim: This study evaluated cuspal flexure, flexural strength, flexural modulus and fracture toughness of experimental resin-composites reinforced with zirconia and alumina nanofibers. [7] In this research paper, we report that cobalt nanoparticles supported on alumina nanofibers (Co/Al2O3) are acting as active nanocatalyst for catalytic hydrolysis of methylamine-borane. [8] This study presents the silane functionalization of alumina nanofibers and its effect on the ballistic performance of the E-Glass polyester composites. [9] Alumina nanofibers were reinforcing additives with an amount of 1, 5 and 10 wt. [10]이온 선택성은 전도성 탄소 코팅이 된 알루미나 나노 섬유로 제조된 C-Nafen 멤브레인에 대해 0 전류에서 멤브레인 전위를 측정하여 실험적으로 조사되었습니다. [1] 이 작업은 세 가지 유형의 나노 구성 요소인 알루미나 나노섬유(0.0.1)를 참조 HPFRCC에 통합하여 달성된 앞서 언급한 개념의 효율성을 보여줍니다. [2] 이 연구에서 우리는 수성 매질에서 페놀 검출을 위해 알루미나 나노섬유와 폭발 나노다이아몬드를 기반으로 하는 새로운 복합 재료를 제안합니다. [3] 본 연구에서는 미세 합성 폴리프로필렌(PP) 섬유 표면에 실리카(SiO2) 나노 입자를 졸-겔 공정을 통해 증착하고 알루미나 나노섬유(ANF)와 결합하여 시멘트 복합재료의 기계적 특성을 향상시켰다. [4] 알루미나 나노섬유(ANF)와 변형된 폭발 나노다이아몬드(MDND)의 합성물은 구성 요소의 수성 현탁액을 5:1의 중량비로 혼합하고 32°C에서 15분 동안 혼합물을 배양하여 생성되었습니다. [5] 피로인산에 알루미늄을 아노다이징하면 차단성 산화막, 다공성 산화막, 알루미나 나노섬유로 이루어진 피라미드형 다발 구조, 완전히 구부러진 나노섬유가 연속적으로 형성된다. [6] 목적: 본 연구는 지르코니아와 알루미나 나노섬유로 강화된 실험용 수지 복합재료의 교두 굴곡, 굴곡강도, 굴곡탄성률 및 파괴인성을 평가하였다. [7] 이 연구 논문에서 우리는 알루미나 나노섬유(Co/Al2O3)에 지지된 코발트 나노입자가 메틸아민-보란의 촉매적 가수분해를 위한 활성 나노촉매로 작용한다고 보고했습니다. [8] 이 연구는 알루미나 나노섬유의 실란 기능화와 E-유리 폴리에스테르 복합재의 탄도 성능에 미치는 영향을 제시합니다. [9] 알루미나 나노섬유는 1, 5 및 10wt의 양으로 보강 첨가제였습니다. [10]