Introduction to Low Peak

It is a common phenomenon that water transfers in unsaturated coal and iron ore, particularly during experiencing vibrations with low peak acceleration, such as during transport by conveyors or ships.

The TL studies were carried out for the prepared phosphors using UV radiation (UV 254 nm), and a single glow peak was found in this study.

A well resolved Thermoluminescence (TL) glow peak at ~168 °C was observed in Cd-borate glass doped WO3.

The results yield three superposition glow peaks at three different temperature ranges.

In order to solve the problem of uneven spatial distribution of human motion image and low peak signal-to-noise ratio (PSNR) of image reliability enhancement, a reliability enhancement algorithm for human motion recognition based on knowledge graph is proposed.

, 1991), validation of exhumation models requires robust estimates of pressure and temperature across the full range of retrograde conditions which follow peak metamorphism.

After 24 h, the maximum heights of TL glow peaks at 180 and 320 °C were about 7 and 4% less than that of the readouts at half an hour later the irradiation.

Moreover, delayed pubertal growth spurt and low peak bone mass may explain the high incidence of fracture in SCD adolescents.

Delocalised recombination models have been mainly applied to the simulation of glow peak shapes, although comparison with experimental data has proven difficult if not impossible due to the scarcity of materials with demonstrably proven 'single-peak' glow curves.

A simulation model is developed, that includes a suitable stress–strain model, and shows a significant reduction of the energy flow peaks.

Features of TSAB converters include soft charging and discharging of capacitors, zero voltage switching, low peak and rms current stresses, low energy storage requirement of magnetic components, and regulation capabilities using simple phase-shift control.

The sample's glow curves were analyzed using glow curve deconvolution (GCD), whole glow peak (WGP) and initial rise (IR) methods.

Based on this design, a stable dual-wavelength lasing was established with a low peak power fluctuation of 0.

Under 2 °C of global warming, the relative contribution of snowmelt and rainfall to streamflow peaks is projected to remain close to that of the current climate, despite slightly increased rainfall contribution.

The kinetic parameters were determined for the intense glow peak.

The TL glow curves showed a prominent glow peak at ~400 K, a smaller intensity peak at 510 K and a very weak intensity glow peak at ~640 K.

TL glow peaks were observed at 350 and 550 K after X-ray irradiation, at 390 and 550 K after He ion irradiation, and at 400 and 600 K after neutron irradiation.

The maximum freshwater flux derived from SIV outflow peaks in March is 65 km 3 (i.

Two TL glow peaks of CaF2:Nd3+,Ce3+ phosphor are centered at around 90 and 265 °C (with a heating rate of 2 °Cs−1).

A number of methods (initial rise, peak shape and curve fitting) were used to fit the TL glow peaks of the PPLG samples obtained under photon dose of 200 Gy.

Low peak bone mass (PBM) is a major contributor to later osteoporosis risk.

DISCUSSION New York LatinX farmworkers do not appear to have abnormal rates of respiratory symptoms or low peak flows.

Accordingly, the converter operating along the control curve can take advantage of high average and low peak current of CCM, small switching loss of DCM.

48 eV responsible for deconvoluted glow peaks at 417.

Multi-element transmit arrays with low peak 10 g specific absorption rate (SAR) and high SAR efficiency (defined as ( $\text{B}_{{1}}^{+}/\surd _{\text {peak}}$ SAR $_{\text {10g}}{)}$ are essential for ultra-high field (UHF) magnetic resonance imaging (MRI) applications.

The remaining patients ( n  = 339) were used to validate the diagnostic performance of the mitral early-diastolic inflow peak velocity (E)-to-left atrial reservoir strain ratio (E/LASr) in left ventricular diastolic dysfunction.

Several features of the vertical base and precious metal distributions (in a composite stratigraphic section based upon two deep exploration drill holes) display similarities to those of offset-type PGE reefs that formed under the overall control of Rayleigh fractionation: (1) composite layering (at several scales) defined by systematic vertical variations of sulfide and precious metal contents and intermetallic ratios, indicating repeated cycles of PGE enrichment and depletion in the order Pd-Pt-Au-Cu, and (2) in the lower part of the reef, stratigraphic offsets of the precious metal peaks below peak sulfide (Cu) content.

Glow curve deconvolution based on first-order kinetics is employed to extract the dose response of the various glow peaks.

Lastly, we model a dynamic rupture “tsunami earthquake” with low rupture velocity and low peak slip rates but twice as high tsunami potential energy.

The Unified Interaction Model (UNIM) simulates the linear/supralinear dose response of the glow peaks of LiF:Mg,Ti (TLD-100) and other thermoluminescent materials and the dependence of the supralinearity on photon/electron energy.

35 thousand years ago and confirm that flow peaks during these events were at most a third of previous estimates.

These results highlight the importance of possibly including CRF in the risk assessment of patients with SDB and, conversely, that of screening for SDB in patients with low peak VO2.

Besides this, the martensite lath widths affected the mechanical properties for the samples with low peak temperatures.

We suppose that it’s necessary to treat the extrasystoles more than 3000 per 24 hours that appear early in cardiocycle (before the mitral valve opening and before the transmitral blood flow peak).

Furthermore, different hyper setting results in distinct forecasting while one case can trace light load hours, the other one can follow peak load hours, more accurately.

79) at low significant wave height and low peak wave period, the transmission coefficient is highest (0.

A high stress area at the bump pad edge was observed at the reflow peak temperature, which is the solder resist crack root cause.

We have recently demonstrated the use of contactless radiofrequency pulse sequences under dissolution-dynamic nuclear polarization conditions as an attractive way of transferring polarization from sensitive 1H spins to insensitive 13C spins with low peak radiofrequency pulse powers and energies via a reservoir of dipolar order.

The 3-electrode system displayed high current levels with low peak-to-peak potential separation, yielding highly stable signals after consecutive electrode bending that corresponded to high active areas.

We find that the Edge TPU suffers from three major shortcomings: (1) it operates significantly below peak computational throughput, (2) it operates significantly below its theoretical energy efficiency, and (3) its memory system is a large energy and performance bottleneck.

In the simulation with the blood flow peak velocity of 0.

Peak systolic CSF velocities were measured at nine axial planes using 2D PC MRI, which were then compared to 4D Flow peak systolic velocity measurements extracted at those exact axial positions along the model.

They exhibited two TSL glow peaks at around 90 and 210 °C.

In order to overcome the problems of low peak signal-to-noise ratio (PSNR), low structure similarity index and resolution coefficient not close to 1, a digital media dynamic target image correction method based on virtual reality is proposed.

The occurrence of RA, occurrence of diabetes, tobacco smoking, higher activity of antibodies against cyclic citrullinated peptide and current use of methotrexate are the risk factors for low peak of global CS.

In TSL, three glow peaks at around 50, 220, and 350 °C were observed, and these peaks were attributed to cation antisites and V center.

CTDW enhanced the cement hydration kinetics compared with limestone, increasing the main heat flow peak, 24- and 168-hour cumulative heat values by up to 8%, 5% and 6%, respectively, for the same incorporation level.

049), low peak oxygen consumption (p = 0.

Analysis of TL glow curves using fractional glow and deconvolution reveal that there are four glow peaks at 154, 211, 273 and 327 °C in the glow curve of ulexite.

The absorption, emission, and thermoluminescence glow peaks of the undoped and Tm-doped KMgF3 were compared.

The remaining patients had absent or mild aortic valve insufficiency with very low peak and mean transvalvular gradients (16 ± 3.

In EDM process, good surface quality can only be produced if low peak current is used but the machining process will take a long time causing material removal rate (MRR) to be too low.

We show that the electrical resistivity exhibits a narrow but low peak at the transition, which may be ddifficult to detect on top of the main contributions induced by phonons and impurities.

Second, using additional subseries reconstructed by the wavelet transform improves predictability, particularly for flow peak.